Sample prices for 1x primary coil, 2x identical secondary coils up to 100V. Delivered with 1x mounting plate and 2x rubber pads.
Please note: Only examples! We manufacture to your specification*,...
Even when your data uniquely defines which layer the top or bottom layer is, the layer orientation cannot be determined without an inscription in the copper, since nearly every CAD program permits a...
Large copper areas in grid form
Large copper areas on your circuit board should always be a grid if possible. This can usually be set in the layout program. For instance, a gridded area is called...
For cost-saving or technical reasons (such as improved assembly), multiple circuit boards may be combined to form a “panel”. This panel is then produced just as a single large circuit board. A...
Surface
In this section of the Design-Aid, we provide all information regarding the PCB surface.
Conductor / Copper thickness informs about the perfect ratio of chosen copper thickness to...
The following table shows the maximum allowed conductor trace width with the minimum conductor trace spacing, depending on the respective copper thickness.
Inner layers
Copper thickness min....
Disadvantages:
Extra charge
Advantages:
Absolutely flat Very good for alu-wire-bonding Very good for gold-wire-bonding Very good for fine pitch, SMD Very good wetting characteristics Good...
Solder-stop type
Depending on the production line and utilization, we are usinge various brands and processes for the solder-stop. These brands behave technically absolutely equivalent but can...
Marking print
A marking print is helpful for error-free manual assembly, but also for including a revision number or UL-number on the circuit board. Multi-CB can provide marking prints in the...